8
2.2a Suspension adjustment
The front and rear suspension can both be fine-
tuned to work well for you. The rear suspension
can be adjusted by a combination of selecting
one of three different hardness and five different
fitting positions for the elastomer. The front
suspension can be adjusted by selecting one of
three different hardness elastomers. All trikes
come with medium elastomers fitted to both
front and rear suspensions. Other elastomers
are available for purchase from ICE.
Rear suspension
The adjustment is accomplished by the selection
of elastomers and mounting positions. The
elastomers are available in three hardnesses:
Yellow/Soft, Red/Medium, Green/Hard. There
are five mounting positions; the lowest/closest
to the main pivot (numbered 1 here) will make
the suspension feel softer. The highest/furthest
from the main pivot position (5) will make the
suspension feel harder.To setup the suspension
you will need to select an elastomer and position
it by using the table on page 9.
Elastomer positions
Unclip the rear suspension by pulling the
stainless steel clip on the left hand side over
its pin. The purpose of this clip is to keep the
rear swing arm from dangling when the trike is
picked up; it is only unclipped when changing
the elastomer .
