5
SETTING A.C. LINE
VOLTAGES
The game comes with 4 available line voltage set-
tings as described below. These settings should be
used to provide A.C. power in the correct range to
the game without over or under powering it.
POWER RANGE
VOLTAGE SETTING
90-110 V.A.C.
115
110-130 V.A.C.
125
200-220 V.A.C.
230
220-250 V.A.C.
250
The game uses a POWER MODULE to handle all of
the A.C. power distribution chores of the game. It
incorporates an On-Off switch, primary A.C. game
fusing, and power switching capabilities. This allows
the game to be used with a wide variety of A.C. volt-
ages by re-strapping the main transformer.
A.C. LINE VOLTAGE
ADJUSTMENT
To adjust the game for a different A.C. voltage:
Unplug the game from the outlet.
Disconnect the power cord from the power
module.
Using a small flat blade screwdriver, pry the
fuse holder from the power module.
Notice a small window on the fuse holder
with an arrow that points to the voltage the
game is presently set at.
Using a small flat blade screwdriver, lift the
retaining tab that holds the voltage selector
in the fuse holder.
Rotate the voltage selector until the voltage
you want is displayed in the voltage select
window.
Push the voltage selector back into the fuse
holder until it snaps into place. NOTE: Do not
force the selector into the fuse holder. If it
does not go in easily, it is not being installed
correctly.
ASSEMBLY
Snap the fuse holder assembly back into the
power module.
Plug the power cord back into the receptacle
in the power module, and into the wall outlet.
NOTE: WHEN CHANGING VOLTAGES FROM THE
115-125 TO 230-250 RANGE, LOWER THE MAIN
FUSE AMPERAGE VALUE BY ½.
WHEN CHANGING FROM THE 230-250 TO 115-
125 VOLT RANGE, DOUBLE THE MAIN FUSE AM-
PERAGE VALUE.
Plug the game in, turn the power on and play a
couple of game. Pay attention to the sound vol-
ume of the game.
ADJUSTING VOLUME
There are two volume control potentiometers on the
Main P.C. Board. The top one controls the theme
music and the bottom one controls the sound effects
such as Duck sounds, etc. Adjust these during game
play.
FINAL ASSEMBLY
After the volume is adjusted, proceed to the set up /
testing section to prepare the game for your location.
When all testing is done, re-install the "Wacky
Ducks™ Sign, remove the keys, and roll the game
into its final location. Lower the adjustable leg level-
ers to keep the game from moving.
YOUR GAME IS NOW READY TO PLAY. IF
YOU HAVE ANY FURTHER QUESTIONS OR
COMMENTS REGARDING THE GAME,
PLEASE CALL OUR SERVICE DEPARTMENT
AT 1-716-859-0360
