ICE Games Frogger, Owner'S And Service Manual

Page: 8 / 31

8
Card Swipe Installation Example
There are many card swipe systems available today. The following information is general and you
should refer to your installation instructions that has been included with your card swipe system for
specific details. If your game was not ordered with blank coin doors then you can order replacement
blank coin doors from our Service Department. The wire that went to the coin switches will need to
be hooked up to your card swipe system to inform the game to start when a card is swiped and ac-
cepted. Most card swipe systems use a Normally open relay to accomplish this. The coin wires
have two wires connected to it, one being a ground and the other the coin line. Connect the coin line
to one side of the normally open relay connection on your card swipe unit and then connect the
ground wire from the coin switch to the other side of it. Now when the relay is activated, it will con-
nect the coin line to ground just like the coin switch would and give the game a credit.
This game has one ticket dispenser per side and a single meter to count the tickets paid out. It is
recommended to splice into the meter lines. The red wire has a constant 12 volts of DC current to it
and the black wire is switched to ground for every ticket that is dispensed. Be sure when splicing
your card reader to the meter that you match the “+ meter” label to the red wire and the “- meter” la-
bel to the black wire. See below for details.
On some card systems the coin meter also needs to be spliced into. The red wire has a constant 12
volts of DC and the black wire is switched to ground for every coin accepted. Be sure when splicing
your card reader to the coin meter that you match the “+ meter” label to the red wire and the “- meter”
label to the black wire. See below for details. On some swipe models you can attach more than one
station per board. In systems that do not support this, you will need to install one system per station.
N
ot
use
d
From ground of coin switch.
From coin return of coin switch.
DATA
DISPLAY
1
2
3
4
1
2
P3
P2
P1
P4
P8
P9
From
Coin
Meter
00000
From
Ticket
Meter
00000
1
2
3
Example of wiring for most Card swipe Systems
To Ga
m
e
Game Setup