ICE COBOTICS i-Synergy RS28L-CY, Operator'S Manual

Page: 11 / 45

ICE RS28L-CY 11
OPERATOR MANUAL
WARNING: Before performing any
maintenance on the machine, be sure that
the power is turned off, or the batteries are
disconnected!
WARING: Repairs are to be completed
by Authorized service centers only. Any repairs
completed by unauthorized persons will avoid
the warrenty.
DAILY MAINTENANCE
1. Remove pad driver/ brush and clean with
approved cleaner.
2. Drain recovery and solution tanks completely
and rinse out with clean water. Visually check
the recovery tank for debris and clean out as
necessary.
3. Raise the squeegee assembly off floor and wipe
it down with a damp towel. Be sure to store the
squeegee in the up position.
4. Remove the vacuum fan inlet filter and rinse it
out with clean water.
5. Clean machine with an approved cleaner and a
damp towel.
6. Recharge the batteries.
7. Check the condition of the squeegee blade
wiping edge, rotate blade if worn.
MONTHLY MAINTENANCE
1. Clean the battery tops to prevent corrosion.
2. Check for loose battery cable connections.
3. Inspect and clean the recovery tank cover seal.
Replace it if damaged.
4. Lubricate all grease points and pivot points with
silicon spray and approved grease.
5. Check the machine for loose nuts and bolts.
6. Check the machine for leaks.
MACHINE STORAGE
1. Always store the machine indoors.
2. Always store the machine in a dry area.
3. Always store the machine in its upright position.
4. Always store the machine with the pad driver/
brush raised off the floor.
5. Always store the machine with the squeegee
assembly raised off the floor.
6. If storing in an area which may reach freezing
temperatures, be sure to drain all fluids from the
machine prior to storage. Any damage caused
by freezing temperatures will not be covered by
the warranty.
7. Drain the recovery tank.
8. Drain the solution tank of all fluid.
PREVENTATIVE MAINTENANCE
FAULT CODE & SOLUTION
The machine equipped with a 7-inch touch screen
(Machine components, # 14), the touch screen will
display Battery meter (Machine components, #28),
Date and Time (Machine components, #29), and
Working accumulated hours (Machine components,
#34).
When the machine detects a fault, there will have
a Fault icon blinking (Machine components, #39)
on the touch screen accompany an audible alarm
Occasionally.
The Fault icon have 2 colors. Yellow icon
represents a low level fault, you can click it to pop
up a fault message window, it will guide you how to
eliminate the fault.
Red icon represents a serious fault, the fault
message window will pop up automatiaclly, you can
not close it unless the fault be eliminated.
Once the fault icon occuring, please DO NOT
continue operate machine unless the faults are
eliminated.
Turn off the machine, then to solve the fault, the
fault icon will be eliminated when machine restart.
If the fault icon is occurred frequently, or can't be
eliminated, please contact ICE service center.
Please refer to the below table to determine the
fault cause and the solution.