Page 7
Now place the reserve chute like a snake in the container. Take care to use the
full length and width.
15. Close the first three rescue flaps and secure them with a small line loop.
This method will avoid burns from a deployment since the bundle of lines will
be released first and will not encounter the material.
16. Starting at the main riser, loop the line bundles in the shape of a figure-eight.
Use silicone-based rubber rings to fix the line bundles
. Make sure that
there is no line knot in the line loop.
17. Make sure to leave approximately 30 cm free to the first figure-eight. This
length is needed for the final line loop.
18. Place the line bundles in the designated line pocket inside the reserve
container.
19. Secure the fourth and final rescue flap with the remaining line length (30 cm).
Your rescue system is now packed!
Use of this parachute with any alternative inner container: Speed of opening
and opening shock test has been completed using the inner container
supplied. Use of any other container may produce different results
(including failure).
Make sure that no tools used for packing (e.g. packing cord) remain in the
packed reserve.
Installing your rescue handle
Most harnesses have a handle for the harness containers. This handle must be
connected to the inner container. Handles for front and back containers are
generally suspended in the central loop, container on side or under the seat, the
side strap used.
The inner container of ICARO rescue systems has two loops, in which the handle
of the harness can be attached (center, side).
Note the instructions for the rescue unit in the operating instructions of your
harness. If there is no handle of the harness or it does not fit with your inner
container, please ask the dealer of your harness or your paragliding school.
Attachment of the connection belt with the harness
For connecting the two belts use a fixable 24 kN- snap hook with a diameter of
8 mm. It is very important that the snap hook cannot twist to prevent rotation stress
of the snap hook. Therefore, use cable fixer, adhesive tape or strong rubber bands
and pull it
above and below the snap hook
around the belts.
Summary of Contents for SQUARE Light 90
Page 1: ...EN...
