8
3.2
Restore Factory Default Setup Introduction
Important
Please use RESET button when device is running. See Figure 3-4 for the location of RESET
button, which is the same for both vandal-proof dome and non vandal-proof dome.
Step1
Take down the dome from the installation pedestal.
Step2
Open the small cover on the back of the device, for vandal-proof dome (Figure 3-4), you need to
dismantle two screws; for non vandal-proof dome, you only have to upwarp the small cover along the
semicircle arc edge.
Step3
Long press the RESET button to complete the reset function. See Figure 3-4.
Step 4
Install the small cover back to the device
Step 5
Install the dome back to quick installation pedestal
Figure 3-4
3.3
SD Card Removal and Installation
Note:
Cut off the power when you need to remove and install SD card, power on after you finish SD card
