Parameter
Description
Buzzer
Select the check box to activate the onboard buzzer when an event
occurs.
Alarm Tone
The NVR will play a specified audio file when the event occurs.
To enable, check the box and then select the corresponding audio file
from the drop-down list.
Refer to "4.18.1 File Management" to add audio files.
Step 3
Click
Apply
to save the settings.
● Click
Default
to restore the default setting.
● Click
Copy to
, in the
Copy to
dialog box, then select the additional channel(s) that
you want to copy the motion detection settings to, and then click
Apply. Note:
This is
not recommended as typically each camera (if looking at a different view), may
require its own specific settings.
4.8.5.1.1 Setting the Motion Detection Region
The NVR and supported IP cameras allow up to four different regions per channel. These
regions can be configured with their own Sensitivity and Threshold settings.
Step 1
Next to
Region
, click
Setting
.
The region setting screen will be displayed.
Step 2
Point to the middle top of the interface.
The setting interface will be displayed. See Figure 4-183.
Figure 4-183
Step 3
Configure the regions settings. You can configure totally four regions.
● Select one region, for example, click
.
● Drag on the screen to select the region that you want to detect.
● The selected area shows the color that represents the region.
● Configure the parameters. See Table 4-55.
181
Summary of Contents for 1U POE NVR Series
Page 1: ...User s Manual V4 1 1 ...
Page 106: ...Figure 4 92 Figure 4 93 Step 2 Configure parameters See Table 4 26 95 ...
Page 291: ...280 ...