IC Realtime 1U POE NVR Series, User Manual, Page: 188 / 291

Parameter Description
Post Record
When the event ends, the alarm will extend for the specified time. The
time range is from 0 seconds to 300 seconds.
Tour
Click to select the check box and then select the channel(s) for the
tour. When the event is triggered, the local interface of the NVR
device will display the selected channel(s) on the screen.
● It is recommended to set the interval and tour mode beforehand.
See "4.17.2 Tour".
● After the tour ends, the previous screen split mode will resume.
Picture Storage
Select the Picture Storage check box to take a snapshot of the
selected channel.
To use this function, select Main Menu > Advanced Settings
> Camera Configuration > Encode > Snapshot , and then
select Event (Trigger) in Type list.
Log
Select the check box, the NVR device records the alarm information in
the log when an alarm event occurs.
Alarm Tone
The NVR will play a specified audio file when the event occurs.
To enable, check the box and then select the corresponding audio file
from the drop-down list.
Refer to "4.18.1 File Management" to add audio files.
Buzzer Select the check box to activate the buzzer when an alarm event
occurs.
Step 5 Click Apply .
4.8.4 Alarm Control
This allows you to configure the alarm output operation (Auto/manual/off). The normal operating
mode should be “Auto”. See below for options:
● Auto: Once an event occurs, the NVR can generate an alarm.
● Manual: This manually triggers the device connected to the alarm output.
● Off: Disables the alarm output function.
Step 1 Select Main menu > Advanced Settings > Alert Center > Alarm-out Port .
The Alarm-out Port interface will be displayed. See Figure 4-181.
177