Step 2
Draw the detection rule.
1) Click
to draw the rule on the live view. See Figure 4-151.
Figure 4-151
2) Set parameters. See Table 4-41.
Table 4-41
Parameter
Description
Preset
For a PTZ camera, select the preset to set up the IVS rule on.
Name
Input customized rule name
Duration
Set the minimum time that the object stays until the alarm is triggered.
Filter target
Click
to filter the target. Click and hold the blue wireframe and
drag to adjust the size of the area with the mouse.
Each rule can set 2 target filters (maximum size and minimum size),
that is, when the passing target is smaller than the minimum target or
larger than the maximum target, no alarm will be generated. The
maximum size should not be smaller than the minimum size.
3) Draw a rule. Left-click mouse to draw a zone until you draw a rectangle. Right click
the mouse when finished.
4) Click
OK
to complete the rule setting.
Step 3
Click
, you can refer to "4.7.2.4.1 Tripwire" to set other parameters.
Step 4
Click
Apply
to complete the setup.
4.7.2.4.6 Parking
The Parking IVS rule triggers when a detection target stays in the defined monitoring area
145
Summary of Contents for 1U POE NVR Series
Page 1: ...User s Manual V4 1 1 ...
Page 106: ...Figure 4 92 Figure 4 93 Step 2 Configure parameters See Table 4 26 95 ...
Page 291: ...280 ...