preliminary
preliminary
iC-PZ AN1
GETTING STARTED GUIDE iC-PZ
Rev A1, Page 2/10
GENERAL SETUP AND REQUIREMENTS
Figure 1 shows the setup used in this application note.
It consists of
•
Motherboard (iC-PZ EVAL PZ1D)
[1]
•
Scanner module (iC-PZ2656 EVAL PZ1M)
[2]
•
BiSS-to-PC adapter (iC-MB4 iCSY MB4U)
[3]
•
Drive with mounted code disc (PZ03PS)
[4]
•
A PC with running Windows 7 operating system.
Note:
Other BiSS-to-PC adapters like iC-MB3 iCSY
MB3U, iC-MB3 iCSY MB3U-I2C and iC-MB5 iCSY
MB5U can also be used. In any case, the related
driver has to be installed before connecting the BiSS-
to-PC adapter to the PC. The latest drivers are
available at
. A com-
parison of the different adapters can be found at
www.ichaus.de/MB3AN2_appnote_en
Note:
The graphical user interface (GUI) software
requires a windows operating system and the Lab-
VIEW
™
Run-Time Engine (RTE). See chapter SOFT-
WARE SETUP for further information.
Note:
The adjustment procedures described in chap-
ters PROCEDURE FOR AUTOMATIC ELECTRICAL
ADJUSTMENT and PROCEDURE FOR MECHANI-
CAL ADJUSTMENT are applicable for other setups
as well if the respective electrical connections are
correct.
Figure 1: Hardware setup: Motherboard
[1]
, scanner module
[2]
, BiSS-to-PC adapter
[3]
and drive with
mounted code disc
[4]
