1
TBS2603 PoE HDMI Video Encoder/Decoder User Manual
Preparations:
1.
Connect HDMI signal to Encoder
2.
Connect LAN cable to Encoder. You can connect Encoder to network switch or a Router.
3.
Prepare a PC/Laptop and then power on for your Encoder.
DC 12V
: power port. These recommended power adapters are “DC 12V/2A or 5V/2A”. DC 12V/1A
adapter is also ok.
Eth
: RJ.45 port, 1000M. If it’s powered over Ethernet, it requires a PoE Network Switch. And also,
the LAN cable should be CAT 5 or higher (CAT 6/CAT 7).
Reset
: Reset button. Press and hold it around 8 seconds and then release, reset active.
After reset, IP will back to the default 192.168.1.217. And also configuration will back to the
default.
HDMI OUT
: Decode and then HDMI out.
