IBM xSeries 440 8687, Hardware Maintenance Manual

Page: 35 / 258

b. Select Advanced Setup from the main menu.
c. Select Static Partition Settings .
d. Type the IP address of the Remote Supervisor Adapter in the secondary
server in the Secondary Host Name field.
e. Select Save Static Partition Settings and follow the prompts.
f. Exit the Configuration/Setup Utility Program.
g. Turn off both servers; then, continue with “Cabling the servers.”
Cabling the servers: This section contains instructions on how to cable two
xSeries 440 servers together in a 16-way configuration.
1. Label each end of the long SMP Expansion cables according to where they
connect to each server (see the following illustration).
Note: The SMP Expansion module numbering shown in the following illustration
is for reference purposes only. These numbers do not appear on the
servers.
Primary server
Secondary server
1 2 3
1 2 3
1 2 3
1 2 3 1
0
3
2
2. Connect the SMP Expansion cables to the primary server.
a. Connect one end of a long SMP Expansion cable to port 1 of SMP
Expansion Module 0 on the primary server; then, route the cable through the
Configuration
23