IBM xSeries 380, Hardware Maintenance Manual

Page: 187 / 324

FRU information (service only)
177
Note: Fully loaded, the Processor/Memory Complex weighs 16.33 kg (36 lbs).
Minimally configured, the complex weighs 10.89 kg (24 lbs).
Statement 4
CAUTION:
Use safe practices when lifting.
Processor/memory complex removal
Complete the following actions to remove the processor/memory complex.
Note:
• Read “Before you begin” on page 136.
• Read “Safety information” on page 257.
• Read “Handling electrostatic discharge-sensitive devices” on page 260.
1. Power down the system:
a. If the server is running an operating system, use its commands or GUI to
logoff (if necessary) and exit the operating system. Successfully exiting the
operating system causes the following prompt to appear:
Shell>
b. After this prompt appears, press and hold the Power button for several
seconds. Holding the Power button in powers down the server.
Note: Powering down the server with the Power button does not remove all
power from the system. The +12 Volt standby power is still available to
the system even when it has been powered down. To remove standby
power from the system you must unplug both power cables from the
chassis.
2. After the server shuts down, unplug both AC power cords to remove standby
power from the server.
Statement 14
≥ 18 kg (37 lbs) ≥ 32 kg (70.5 lbs) ≥ 55 kg (121.2 lbs)