IBM xSeries 206m, Problem Determination And Service Manual

Page: 75 / 144

Removing the system board
To remove the system board, complete the following steps:
1. Read the safety information that begins on page vii, “Installation guidelines” on
page 27, and “Handling static-sensitive devices” on page 28.
2. Turn off the server, and disconnect all power cords and external cables; then,
remove the server cover (see “Removing the cover” on page 30).
3. Remove the riser-card assembly with adapters, and place them on a
static-protective surface for reinstallation (see “Removing an adapter” on page
32).
4. (Hot-swap model only) Remove the SAS/SATA controller (see “Removing the
SAS/SATA controller” on page 52) and place it on a static-protective surface for
reinstallation.
5. Remove all DIMMs, and place them on a static-protective surface for
reinstallation (see “Removing a memory module (DIMM)” on page 38).
6. Disconnect all cables from the system board.
7. Remove the microprocessor heat exchanger assembly and microprocessor;
then, place them on a static-protective surface for reinstallation (see
“Removing the microprocessor” on page 54).
8. Note the orientation of the microprocessor retention module.
9. Unscrew the four screws that hold the microprocessor retention module to the
system board; then, lift the retention module out of the server.
Chapter 4. Removing and replacing server components
59