IBM TURBOWAYS 622 PCI MMF ATM, Installation And Using Manual

Page: 21 / 44

Chapter 5. Installing the TURBOWAYS 622 PCI MMF ATM Adapter
This chapter provides instructions for installing the TURBOWAYS 622 PCI MMF ATM
Adapter.
To install the adapter, do the following:
1. Be sure you have read “Chapter 2. Preparing for Installation” on page 3 to
determine:
v
If you should install your adapter hardware first, go to step 2 and continue with
this section.
v
If you should install your device driver software first, go back to “Chapter 3.
Installing Device Driver Software” on page 5. Return here to install your
hardware.
2. If your system supports hot-pluggable PCI adapters, return to “Verifying Adapter
Hardware Installation” and refer to your system documentation to install the adapter.
If your system does not support hot-plugging, continue with the next step.
3. Log in as a root user and, at the system prompt, type:
shutdown
then press Enter. When
halt completed
displays, turn off the system unit power and
unplug the power cord from the wall outlet.
Note: Refer to your system unit documentation for further shutdown information.
4. Remove the covers of your system unit. Follow the instructions provided in your
system unit documentation.
5. Install the adapter into an available PCI slot in your system unit. See the
instructions in your system unit documentation for installing PCI adapters. Refer to
your
PCI Adapter Placement Reference guide for slot locations.
6. Follow the directions provided in your system unit documentation to reinstall the
covers of your system unit.
7. Plug the power cord back into the wall outlet.
8. Turn on the power to your system unit.
Verifying Adapter Hardware Installation
To verify that your system unit recognizes the PCI adapter, do the following:
1. If necessary, log in as root user.
2. At the command line, type:
lsdev -Cs pci | grep atm
3. Press Enter.
A list of PCI devices displays. If the TURBOWAYS 622 PCI MMF ATM Adapter did
install correctly, an
Available
status indicates that the adapter is installed and ready
to use.
13