IBM Turbo 16/4 Token-Ring PC Card 2, User Manual

Page: 27 / 123

power) to PCMCIA cards. Once CS20TOK.EXE has run successfully, the PCMCIA
Token-Ring card is ready to operate and looks much like any ISA Token-Ring
adapter.
Generally, enabling a card is done by loading CS20TOK.EXE in CONFIG.SYS,
AUTOEXEC.BAT, or at a DOS prompt.
For a complete list of CS20TOK.EXE parameters, you can enter the following at a
DOS prompt:
CS20TOK /? or CS20TOK /h
Examples:
In autoexec.bat:
cs20tok sa mmio=d000 sram=d000,4 rs=16 irq=a io=0a20
In config.sys:
device=c:\cs20tok.exe sa mmio=d000 sram=d000,4 rs=16 irq=a io=0a20
Both set the card in slot 1 (sa) to an 8-KB memory region based at X'0D0000', with
the card operating in enhanced mode. The card is assigned port X'0A20', interrupt
vector X'A' (10 decimal), and Token-Ring speed (rs) will be 16 Mbps. The program
runs, then sounds two ascending beeps indicating successful operation. The card is
now enabled and ready for the driver to be loaded.
Here is an example of using CS20TOK.EXE with two adapters:
cs20tok sa mmio=d000 sram=d000,4 rs=16 irq=a io=0a20 pri
cs20tok sb mmio=c800 sram=c800,4 rs=16 irq=9 io=0a24 alt
Novell NetWare 3.12 Server
Before you start this installation, get the latest level of patches for NetWare 3.12
from Novell. The current level is IntraNetWare Support Pack Version 5.0 from the
Novell support Web site at support.novell.com. You will install the patches during
the following procedure.
If the Novell NetWare server is not on your computer, use the following instructions.
If it is on your computer, go to the instructions on page 13.
Server Driver Installation in New NetWare 3.12 Server
Changes from the usual NetWare installation are necessary because this driver is
written to a new specification level that requires new NetWare loadable modules
(NLMs). The installation program is not aware of this, though, and these NLMs must
be loaded during installation of the server device driver and after the server
installation.
1. Create a diskette containing the extracted files from the NETWARE.EXE
package file on the IBM Turbo 16/4 Token-Ring PC Card 2 CD-ROM.
2. Refer to Novell’s Installation and Upgrade manual for installation instructions.
Follow the procedure for the installation of Novell NetWare 3.12 until the
section titled
″
Load LAN Drivers
″
is next.
3. Insert the diskette that you created in step 1 into drive A. Enter the following
commands at the server prompt:
LOAD A:\NOVELL\NETWARE\NBI31X.NLM
LOAD A:\NOVELL\NETWARE\MSM31X.NLM
LOAD A:\NOVELL\NETWARE\TOKENTSM.NLM
Chapter 4. Software Installation
11