IBM TS7650G PROTECTIER DEDUPLICATION GATEWAY, User Manual, Page: 34 / 248

8. Select the device to reassign and the virtual device to assign it to from the
available virtual devices displayed.
9.
When you want to commit the changes, type
c
and press Enter.
10. Type q and press Enter to quit.
11. The system returns you to the prompt command.
What to do next
The procedure is now complete. If the static routes have not been previously
configured, continue to “Configuring static routes.” Then continue to Changing the
system date and time .
Configuring static routes
Complete this task to configure the static routes for replication.
About this task
In this task you will provide information about your source server(s) and the target
server(s), in order to define the static routes.
For assistance with this task, refer to the information on your completed Configure
Static Route for Replication
worksheet(s).
Run this procedure on the source server(s) to configure the addresses of all the
destination systems and the node on which the ProtecTIER Replication Manager is
activated. On the destination server(s), run this procedure to configure the
addresses of the source system(s).
On the ProtecTIER Replication Manager node, all the systems (source and
destination) must be configured.
Procedure
1. Access the ProtecTIER Configuration Menu. See “Accessing the ProtecTIER
Service menu” on page 9.
2. From the ProtecTIER Service Menu, select ProtecTIER Configuration (...) .
Type the corresponding number and press Enter. The ProtecTIER
Configuration (...)
menu is displayed.
14
IBM TS7650G Deduplication Gateway for ProtecTIER
®
: User's Guide for FSI Systems