IBM TS2280, Setup, Operator, And Service Manual

Page: 73 / 142

3. Continue to turn the rewind tool counterclockwise until approximately 13 cm (5 in.) of tape hangs
from the cartridge door. If necessary, grasp the tape and pull gently to unwind it from the cartridge.
4.
Remove the rewind tool by pulling it away from the cartridge. Set the tool and the cartridge aside.
5. On the leader pin (
▌1▐
in Figure 24), locate the open side of the C-clip
▌2▐
. The C-clip is a small
black part that secures the tape
▌3▐
to the pin.
6. Remove the C-clip from the leader pin by using your fingers to push the clip away from the pin. Set
the pin aside and discard the clip.
7. Position the tape in the alignment groove of the leader pin attach tool (see
▌1▐
in Figure 25 on page
52).
8. Place a new C-clip into the retention groove
▌2▐
(Figure 25 on page 52) on the leader pin attachment
tool and make sure that the clip's open side faces up.
9. Place the leader pin (from step 6) into the cavity
▌3▐
(Figure 25 on page 52) of the leader pin attach
tool.
Attention:
To prevent the leader pin from rolling into the cartridge, in the following step use care
when the tape is folded over the pin.
10. Fold the tape over the leader pin and hold it with your fingers (see Figure 25 on page 52).
Figure 23. Winding the tape out of the cartridge. Turn the cartridge manual rewind tool clockwise to see the end of the
tape, then turn it counterclockwise to bring the tape to the cartridge door.
A67E0036
1
2
3
Figure 24. Removing the C-clip from the leader pin. Use your fingers to push the C-clip from the leader pin.
Ultrium media
51