IBM TotalStorage, Installation Manual

Page: 51 / 91

13. Push the latch lock
2
(Figure 31) away from the rail to release the carrier.
The latch-lock carrier slides toward the front of the rack, and the locating pins
project through the holes that are in the front flange and in the front rail
bracket.
Important: Ensure that the locating pins are fully extended through the front
rail bracket.
14. Push the back rail bracket
1
(see Figure 29 on page 28) toward the rear of
the rack and align the locating pins with the rack-mounting flange.
15. Push the latch lock
2
(see Figure 29 on page 28) away from the rail to
release the carrier. The latch-lock carrier slides toward the rear of the rack, and
the locating pins project through the holes that are in the rear flange and in
the rear rail bracket.
Important:
Ensure that the locating pins are fully extended through the rear
rail bracket.
16. On the rear of each rail press the blue release tab and slide the shipping
bracket off the slide rail. Store the shipping bracket for further use.
Installing the SAN Volume Controller into the rack
This task includes the steps you must complete to install the SAN Volume
Controller into the rack.
Prerequisites:
Before you install the SAN Volume Controller into the rack; review the following
caution notice.
1
2
Figure 31. Closing the latch-lock carrier assembly
Chapter 4. Installing the uninterruptible power supply, the master console, and the SAN Volume Controller
29