IBM TotalStorage SAN Volume Controller, Installation Manual

Page: 70 / 123

1
Main power connector
2
Communication port
3
Load segment 1 receptacles
4
Load segment 2 receptacles
7. Press and hold the on/off button
2
until you hear the UPS 5115 beep
(approximately two seconds). The front panel indicators cycle through a startup
sequence while the UPS 5115 conducts a self-test. See Figure 14.
When the self-test is complete, the Power On Indicator
1
and the Load
Indicators (
7
and
8
) illuminate to indicate that power is being supplied by
the UPS 5115. The UPS 5115 is now in normal mode, and is charging its
battery. If the Power on indicator
1
is flashing red and the alarm is sounding,
the voltage range setting might not be correct. When a SAN Volume Controller
is connected to the UPS 5115, the SAN Volume Controller automatically adjusts
the voltage range setting. Take no action for this alarm condition unless it
persists for more than five minutes after a SAN Volume Controller has been
connected to this UPS 5115 and powered on.
1
Power on indicator
2
On/off button
3
Test and alarm reset button
4
Overload indicator
5
On-battery indicator
6
Service indicator
7
Load segment 1 indicator
1
y
z09b
1
2
4
3
Figure 13. Installing the uninterruptible power supply 5115 power cable
+ - + -
LOAD 1 LOAD 2
1
yy
zvm
5
6 7 8
1
2
3
4
Figure 14. Power switch and indicators of the uninterruptible power supply 5115
40
IBM TotalStorage SAN Volume Controller: Installation Guide
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|