Troubleshooting Management Connections
If a serial connection does not occur, cycle power by
removing the power cord, waiting for approximately 5
seconds, and then reinstalling the power cord. In addition,
check the terminal session’s serial port parameters or
replace the serial cable. (Make sure it is a null modem
cable, preferably the cable that shipped with the switch.)
If the Ethernet activity LED is on, make sure you are using
a cross-over Ethernet cable (unless using an Ethernet
hub), or check the IP addresses on the switch and
workstation as follows:
At a command line prompt, type
ping
DNSorIP (where
DNSorIP is the switch’s DNS name or IP address) and
press E
NTER
.
If a
“Reply from…” or “...is alive...” message appears, the
devices can communicate.
If a
“Request timed out” message appears (or the
command times out), the devices cannot communicate.
Trace the cabling. If needed, reconnect the devices.
Documentation
Links to the User’s Guide, Technical Briefs, and other
product documentation are available through the Web
Manager.
To view the latest product documentation, click:
Help > Documentation
.
GC26-7653-00
26K7914
© Copyright International Business Machines Corporation 2004
All Rights Reserved.
© Copyright Emulex Corporation 2004
All Rights Reserved.
00041446-001 Rev. A
Quick Reference
Managing with the Intuitive Web Manager
A quick list of frequent configuration tasks and their
locations is shown below.
To...
Click…
View switch status
Storage Switch
Change general switch settings
Switch > Configuration
Change the IP Address
Switch > Configuration
Change the switch speed
Switch > Configuration
View the event log
Switch > Event Log
Upgrade the firmware
Switch > Files
Change the port settings
Port > Smart Settings
Configure zoning
Advanced Functions >
One Step Zoning
Reset the switch
Reboot
IBM TotalStorage
®
Storage Switch
2006 Model L10
GC26-7653-00
