IBM TotalStorage IP Storage 200i 110, Installation Manual

Page: 41 / 94

Input/output connector locations
Figure 11 shows the input/output connectors (ports) and LEDs on the rear of the
engine.
Input/output ports
This section provides information about the input/output (I/O) ports supported for
your appliance.
Serial ports
Each appliance has two standard serial ports: Serial port A and Serial port B. The
operating system can use and share both serial ports; however, the integrated
Service Console can use only Serial port A.
Video port
Each appliance has an integrated super video graphics array (SVGA) video
controller to which you can attach a monitor. A monitor is not required during
installation or normal operation.
Keyboard port
There is one keyboard port on the rear of your appliance. The keyboard port is not
used during installation or normal operation.
6
7
8
1
DC power LED
2
AC power LED
3
Serial port A
4
Mouse port
5
Keyboard port
6
Ethernet port
7
ISM ports
8
USB ports
9
Serial port C
10
Video port
Figure 11. Input and output connector ports
Chapter 2. Installation procedures
29