IBM TotalStorage FAStT700, User Manual

Page: 34 / 100

Table 1. Tasks overview (continued)
Task Description See
Preparing to move the FAStT700
Storage Server You might need to move the
FAStT700 Storage Server to a new
location or remove the chassis from
its rack cabinet. “Preparing to move the FAStT700
Storage Server” on page 32
Removing the front bezel to access the FAStT Storage Server
components
To access the controllers, battery, storage server fan, and indicator lights, you must
remove the FAStT700 Storage Server bezel, as shown in Figure 20.
Attention: Pulling the cover out too far can damage the plastic hooks at the top.
To avoid damaging the hooks, place the FAStT700 Storage Server on a flat surface.
Be sure the front of the FAStT700 Storage Server extends beyond the edge
approximately 5 cm (2 in.).
1. Carefully pull the bottom of the bezel out to release the pins; then slide the
bezel down, as shown in Figure 20.
FAStT700 bezel
2. To replace the bezel, slip the top edge of the bezel under the lip on the chassis,
then push the bottom of the bezel until the pins snap into the mounting holes,
Figure 20. Removing the FAStT700 Storage Server bezel
16
IBM
®
TotalStorage
™
FAStT700 Fibre Channel Storage Server: User’s Guide