IBM totalstorage fastt100, Installation, User And Maintenance Manual, Page: 115 / 160

v
For SFP modules that contain wire tabs, unlock the SFP module latch by
pulling the wire latch outward 90°, as shown in Figure 66.
c. With the SFP latch in the unlocked position, extract the SFP module.
v
For SFP modules that contain plastic tabs, slide the SFP module out of
the port.
v For SFP modules that contain wire tabs, grasp the wire latch and pull
the SFP module out of the minihub port.
d. Replace the protective cap on the SFP module.
e. Place the SFP module into a static-protective package.
f. Replace the protective cap on the port.
5. Remove the failed RAID controller (the Fault LED is on), as follows:
a. Push down on the latch (centered above the RAID controller). Pull both
levers at the same time out of the locked position.
Protective cap
SFP module
10
o
Plastic tab
F10ug009
Figure 65. Unlocking the SFP module latch - plastic variety
Protective
cap
SFP
module
90
o
Wire
tab
F10ug010
Figure 66. Unlocking the SFP module latch - wire variety
Chapter 5. Installing and replacing components
85