IBM TotalStorage FAStT EXP700, Installation, User'S, And Maintenance Manual

Page: 101 / 158

b. Pull the handle on the tray out so that it is in the open position, as shown in
Figure 53.
Tray handle
Blue latch
e
xp70012
c. Slide the drive CRU into the empty bay until the tray handle touches the
storage expansion enclosure bezel.
d. Push the tray handle down into the closed (latched) position, as shown in
Figure 54.
e
xp70018
Replacing hot-swap hard disk drives
Drive problems include any malfunctions that delay, interrupt, or prevent successful
input/output activity between the hosts and the hard disk drives in the storage
expansion enclosure. This includes transmission problems between the host
controllers, the ESMs, and the drives. This section explains how to replace a failed
hard disk drive.
Figure 53. Drive CRU latch
Figure 54. Closing the hot-swap hard disk drive tray handle
Chapter 3. Installing and replacing devices
69