Table 4: FIDs and FRUs (continued)
Reporte
d FID
FRUs FRU name or description
Prob-
ability
Page reference or instruction
AF
Eight-character operator display problem
85
Drive canister
100% • “FID 85: Drive canister” on page 252
BF
Failure to electronically detect fan motion in the drive canister
Note: This error can take up to 5 minutes to be reported after the condition is detected.
85
Drive canister
100% • “FID 85: Drive canister” on page 252
C1
See 'Reported FID 82' in this table
D0
See 'Reported FID 8A' in this table
D8
See 'Reported FID 8A' in this table
E4
Drive electronics
85
Drive canister
95% • “FID 85: Drive canister” on page 252
EA
Cards and power supply cables
5%
• “FID EA: Cables FRU kit” on page 255
E5
See 'Reported FID 83' in this table
E6
See 'Reported FID 84' in this table
ED
Flashdump
-
Memory dump exists in flash
memory
-
Informational message that the memory dump is
in flash memory. See “Offloading the dump to
flash memory” on page 211 or “Clearing flash
F2
See 'Reported FID 86' in this table
F5
Fibre Channel error
F5
Interface, operator procedural,
or host problem
-
“Fibre Channel problem determination” on page
F6
Informational message--Cleaning required
F6
Operator, procedural, or host
problem
-
-
F7
Fibre Wrap Test Failure
If you are running the Fibre Wrap Test, check the following before you replace the drive canister -
1. If you are running the Wrap Test at the drive itself, ensure that the wrap tool is making a good
connection, or try a different wrap tool. Rerun the test to ensure that the drive canister is at fault.
2. If you are running the Wrap Test through the fibre cable when you received this error, try the
Wrap Test at Drive. If the test runs without error at the drive, replace the cable. If the test still
provides FID F7, replace the drive canister.
-
Fibre Channel cable
10%
85
Drive canister
90%
• “FID 85: Drive canister” on page 252
10 IBM 3592 TS1140, TS1150, TS1155, and TS1160 Tape Drives: Maintenance Information