IBM TotalStorage 2109 M12, Installation And Service Manual

Page: 79 / 159

Note: If you are passing through a narrow passage or door, it might be
necessary to rotate the drawer on the load platform.
8. Set the wheel brake by pressing down on the wheel brake pedal.
9. Locate the anti-tips bars. If they are not attached, attach them to the lift tool by
performing step 9a through step 9d. If the anti-tip bars were previously
attached, go to step 10.
a. Pull up on the leg lock pins and insert the anti-tip bars inside the legs.
b. Pull on the legs and anti-tip bars to ensure that they are locked into
position.
c. Raise the platform to allow enough room to attach the anti-tip bracket.
d. Secure the anti-tip bars by using the anti-tip bracket and bolt.
10. If you are installing the lower M12, go to step 11. If you are installing the upper
M12, go to step 12 on page 50.
11. For the lower M12, install the bridge tool by completing the following steps:
a. Remove the bridge tool from the box and adjust the two supports 45°.
b. Hold the bridge tool between the two vertical supports near EIA unit 3, and
move the two supports another 45°. Make sure that the following conditions
are met:
v
The two-pin section of the support is on the back of the vertical support.
v The one-pin section of the support is on the front of the vertical support.
Rear
SJ000682
Figure 27. Rear view of cabinet and lift tool
Chapter 5. Installing and removing Model M12 switches
49