7.2.3 Apply the Service
1
Apply the new service.
vmfapply ppf 5654A09A {ADSM | ADSMSFS}
Use
ADSM
for installing on minidisks or
ADSMSFS
for installing in Shared File System directories.
This command applies the service that you just
received. The version vector table (VVT) is
updated with all serviced parts and all necessary
AUX files are generated on the alternate APPLY
disk.
You must review the VMFAPPLY message log if
you receive a return code (RC) of a 4, as this may
indicate that you have local modifications that need
to be reworked.
2
Review the apply message log ($VMFAPP $MSGLOG). If necessary, correct
any problems before going on. For information about handling specific error
messages, see
VM/ESA: System Messages and Codes,
or use on-line HELP.
vmfview apply
Note
If you get the message VMFAPP2120W then re-apply any local modifications before building the
new Tivoli ADSM for VM. Refer to chapter 7 in the
VM/ESA Service Guide
. Follow the steps
that are applicable to your local modification.
The following substitutions need to be made:
esalcl
should be
5654A09A
esa
should be
5654A09A
compname
should be
ADSM
or
ADSMSFS
(minidisk or SFS)
appid
should be
5654A09A
fm-applyalt
should be the fm of 4A6
If you have changed any of the installation parameters through a PPF override, you need to
substitute your changed values where applicable.
Keep in mind that when you get to the
"
Return to the Appropriate Section to Build Remaining
Objects
"
or
"
Rebuild Remaining Objects
"
step in the
VM/ESA Service Guide
, you should return
back to this program directory at 7.2.4, “Update the Build Status Table” on page 32.
Service Instructions
31
