IBM ThinkPad X30, ThinkPad X31 (MT 2672, Hardware Maintenance Manual

Page: 54 / 138

Symptom or error FRU or action, in sequence
0189
Invalid RFID configuration
information area—The
EEPROM checksum is not
correct. System board.
0190
Critical low-battery error 1. Charge the battery pack.
2. Battery pack.
0191
System Security—Invalid
Remote Change requested. 1. Run IBM BIOS Setup
Utility, and then save
current setting by
pressing F10.
2. System board.
0192
System Security—IBM
Embedded Security hardware
tamper detected. System board.
0197
Invalid remote change
requested. The remote configuration for
the security chip has failed.
Confirm the operation and try
again.
0199
System Security—IBM Security
password retry count exceeded. 1. Run IBM BIOS Setup
Utility, and then save
current setting by
pressing F10.
2. System board.
01C8
More than one modem devices
are found. Remove one of
them. Press <Esc> to continue. 1. Remove either a Mini PCI
modem card or an modem
daughter card; or press
Esc to ignore the warning
message.
2. System board.
01C9
More than one Ethernet devices
are found. Remove one of
them. Press <Esc> to continue. 1. Remove the Ethernet
device that you installed;
or press Esc to ignore the
warning message.
2. System board.
0200
Hard disk error—The hard disk
is not working. 1. Reseat the hard-disk
drive.
2. Load Setup Defaults in IBM
BIOS Setup Utility.
3. Hard-disk drive.
4. System board.
021x
Keyboard error Run interactive tests of the
keyboard and the auxiliary
input device.
0220
Monitor type error—Monitor
type does not match the one
specified in CMOS. Load Setup Defaults in IBM
BIOS Setup Utility.
0230
Shadow RAM error—Shadow
RAM fails at offset nnnn. System board.
Symptom-to-FRU index
50
ThinkPad X30 (MT 2672/2673)