Warning notices to New Zealand users of the built-in modem
a. A person calling your modem will hear a short burst of ringing before the modem answers. This
confirms that the call has been successfully switched through the network.
b. Caller identification information (which occurs between the first and second ring cadences) is
not destroyed.
4. The pulse dialling option is not compatible with the Telecom Network and must not be used.
This equipment shall not be used in any circumstances which may constitute a nuisance to other
Telecom Customers.
The following setup AT commands should be used for correct operation:
AT19 = North America
AT% T19,0,19(North America)
AT%T21,B,2
AT%T21,B,6
NOTE THAT FAULT CALLOUTS CAUSED BY FAILURE TO ADHERE TO THE ABOVE NOTES MAY
INCUR A CHARGE FROM TELECOM.
Notice for IBM 10/100 Ethernet Mini PCI Adapter with 56K
Modem (by 3COM) users
For the modem with approval number PTC 211/99/255:
Not all phones connected to the phone port will respond to incoming ringing. Do not report this as a
fault unless the same phone will not respond to ringing when connected to a standard phone socket.
This equipment shall not be set up to make automatic calls to the Telecom 111 Emergency Services.
The grant of a Telepermit for a device in no way indicates Telecom acceptance of responsibility for the
correct operation of that device under all operating conditions. In particular, higher speeds at which this
modem is capable of operating depend on a specific network implementation which is only one of many
ways of delivering high quality voice telephony to customers. Failure to operate should not be reported
as a fault to Telecom.
2
Notice to New Zealand Users
