IBM ThinkCentre 8105, Hardware Replacement Manual

Page: 34 / 38

3. Locate the mouse connector.
Note: Your mouse might be connected to a standard mouse connector
1
or a
USB connector
2
. Depending on where your mouse is connected, see
“Locating the connectors on the rear of your computer” on page 2 or
“Locating the connectors on the front of your computer” on page 1.
4.
Disconnect the failing mouse cable from the computer.
5. Connect the new mouse to the appropriate connector on the computer.
6.
Go to “Completing the parts replacement.”
Completing the parts replacement
After working with parts, you need to replace the computer cover and reconnect
any cables, including telephone lines and power cords. Also, depending on the
part that was replaced, you might need to confirm the updated information in the
Setup Utility program.
1. Ensure that all components have been reassembled correctly and that no tools
or loose screws are left inside your computer.
2.
Clear any cables that might impede the replacement of the cover.
3. Lower the drive bay assembly.
4.
Make sure all cables are routed correctly through the cable clip
1
.
5. Close the computer cover.
6. If your computer is being placed in the vertical position, attach the floor stand.
Attention:
To prevent overheating and possible component damage, always
attach the floor stand when placing the computer in the vertical position.
26
Hardware Replacement Guide