Removing a storage enclosure
To remove a storage enclosure, complete the following steps.
1. Read the safety information that begins on page vii and “Installation guidelines”
2. If the storage enclosure is installed on a system-board tray, remove it (see
“Removing an expansion enclosure from a system-board tray” on page 73).
3. Carefully set the storage enclosure on a flat, static-protective surface.
4. Make a note of where the hard disk drives are installed; then, remove them.
Place them on a static-protective surface or install them in the new storage
enclosure (see “Removing and installing a hard disk drive” on page 88).
5. Note the cable routing; then, remove the hard disk drive bracket and cable
6. If you are instructed to return the storage enclosure, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Chapter 4. Removing and replacing server components
119