IBM System Storage TS7650G 3958 DD4, Installation Roadmap Manual

Page: 76 / 232

Table 8. Stand-alone power connections (continued)
Callout From On Device To On Device/Location
4
Power outlet TSSC KVM switch (if you
installed one) (SC TSSC) TJ4 Top PDU
5
Power outlet 1 TSSC (if you installed
one) (SC) BJ5 Bottom PDU
6
Power outlet 2 TSSC (if you installed one
with a second power
outlet) (SC) TJ5 Top PDU
8
Power outlet 1 DD4A TJ8 Top PDU
9
Power outlet 2 DD4A BJ8 Bottom PDU
Procedure
1. Label and connect the power cords according to Figure 11 on page 37 and
Table 8 on page 37.
Note: Depending on the TSSC's configuration, the TSSC may have one or two
power supplies. If only one power supply is present, connect the power cord to
the specified location (BJ4 or TJ4) on either of the PDUs.
2. Go to “Stand-alone fibre channel connections” on page 42.
Stand-alone TSSC and customer network Ethernet
connections
The tasks in this section describe the network Ethernet connections for theTS7650G
server in a stand-alone configuration.
Ethernet connections for stand-alone VTL configuration
The tasks in this section describe the network Ethernet connections used with
theTS7650G server in a stand-alone configuration for OpenStorage.
About this task
Figure 12. Customer and replication Ethernet connections for stand-alone VTL configuration
38
IBM System Storage TS7600 with ProtecTIER: Installation Roadmap Guide
|
|