
Chapter 4. Operations
4-11
•
IP Address
— If
DHCP
is disabled, set the IP address of the library manually.
–
IPv4
— Select to enter the library IP address using the IPv4 protocol.
–
IPv6
— Select to enter four library IP addresses using the IPv6 protocol.
•
Subnet Mask
— If
DHCP
is disabled, set the IP address of the subnet mask.
–
Subnet Mask
— Select to enter the subnet mask address using the IPv4 protocol.
–
Prefix Length
— Select to enter the prefix length for the IPv6 protocol.
•
Gateway
— If
DHCP
is disabled, set the IP address of the gateway.
–
IPv4
— Select to enter the gateway IP address using the IPv4 protocol.
–
IPv6
— Select to enter four gateway IP addresses using the IPv6 protocol.
Configuring Operator Panel Settings
Figure 4-23. Operator Panel settings
Use
Configuration
→
Configure Op Panel Settings
to set the preferences when
using the Operator Panel.
Configure the Operator Panel using the following settings:
•
Back light
— Select to enable the LCD back light when using the Operator Panel.
–
Input Count
— If the auto back light is enabled, specify the time duration before
the back light turns OFF. The setting uses a 4-digit timer in minutes.
•
Login Password
— Select to change the Operator Panel 4-character login
password. The new password must be re-entered for confirmation before the
password is changed (default: 0000).
Setting the Library to Factory Defaults
Figure 4-24. Factory default settings
Use
Configuration
→
Set Default
to reset the library to the factory default settings.
See Table 3-4, “Default library configuration settings,” on page 3-15. The date and
time must be reset after restoring factory default settings. See “Configuring Date and
Time Settings” on page 4-9.
Important:
This configuration setting deletes all current library settings, and should
be used with utmost caution.
Input Count (min)
New Password
Reenter Password
Enable Auto Back Light
Configuration
Configure Op Panel Settings
Configure LCD Back Light
Change Login Password
Disable Auto Back Light
Configuration
Set Default
Summary of Contents for System Storage TS2900
