IBM System Storage TS2900, Setup, Operator, And Service Manual

Page: 202 / 257

B-10
TS2900 Tape Autoloader Setup, Operator, and Service Guide
Web User Interface Error Messages
0222
Media could not be ejected
because drive is in Prevent
Medium Removal state.
CHK 0222
1. Release the drive Prevent Medium Removal
state from the host.
2. Reseat all cables. See “Reseating Cables” on
page 6-10.
3. Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
• If the problem persists, see “Contacting IBM
Technical Support” on page 7-1.
Table B-3. Web user error messages
Title Message Issuing Panel
Error Users full. User Access
You cannot remove yourself. User Access
Parameter Error Login failure. Login
Unsupported update file. Firmware Update
Invalid parameter found in [***]. Configure Library
Please input parameter of [***]. Configure Library
Password parameter error. User Access
User name parameter error. User Access
Not enough role. User Access
An user name unmatched. User Access
An user is already existed. User Access
Users full. User Access
Flush ROM write error detected. User Access
User information access failure. User Access
Command Error Move command execution failure. (Code:”****”) Move Cartridges
Unload execution failure:[****]. Unload Drive
Drive not ready. Unload Drive,
Download Drive Logs,
Firmware Update
Medium not present. Unload Drive
Online command execution failure:[****]. Library State
Offline command execution failure:[****]. Library State
Reset command execution failure:[****]. Reset Library/Drive
Inventory command execution failure:[****]. Inventory
“Normal Dump” command execution failure:[****]. Download Drive Logs
“Force Dump” command execution failure:[****]. Download Drive Logs
Restore failure.
Library serial number is unmatched Save/Restore
Writing to cookie was failure.
The configuration data was not saved to cookie. All
Table B-2. Drive error codes (continued)
Code (H) Description Panel indication Action Required