5
Connecting the N3300 to expansion units
IMPORTANT:
!
N3300 and N3600 Hardware and Service Guide
N3300 and
N3600 Hardware and Service Guide
for more information
for more information
When using onboard ports to connect to EXN expansion units, onboard
ports
be set to initiator mode. See "Configuring for initiator mode" in
the
.
SFPs
be used when connecting fiber cables.
If you are connecting your configuration to a fibre channel switch, see
"Cabling your N3300 system to a fibre channel switch” in the
.
Software disk ownership is activated at boot for all disks on the
system.
must
must
Note:
!
!
11
Cable the Fibre Channel ports according to your configuration:
- For a single-node A10, go to step 5.3 on page 12.
- For a dual-node A20 (clustered), go to step 5.4 on page 13.
Make sure that all expansion unit 1Gb/2Gb(/4Gb) speed switches are
set to the correct position. If necessary, refer to the documents that
came with the expansion unit for information about checking and/or
setting the switch.
The following cabling instructions describe expansion unit cabling using the
onboard Fibre Channel ports on your N3300 system.
5.2
5.1
