4.
Turn on the power to only the expansion units, making sure you turn them on within 5 minutes of
each other.
5.
After you have powered on the storage expansion units, turn on the N3220 filers.
Note:
It takes the LEDs on the system power supplies a few seconds to illuminate.
The system begins to boot, and then it stops at the first installation question, which is displayed on
the console window.
6.
Use the console interface to answer the setup questions for each controller module in your system.
Use the data you collected with the Configuration worksheet.
7.
After you complete the setup, check the licenses on the N3220 filer controller modules by entering
the following command:
license
Add any missing licenses by entering the following command for each missing license:
license add <license_code>
where
<license_code>
is the license code for the product.
Note:
Clustering must be licensed on both nodes in an N3220 HA pair.
8.
Reboot the nodes by entering the following command:
reboot
9.
Enable clustering by entering the following command on one node's console:
cf enable
10.
Check each node's status by entering the following command:
cf status
Initial setup is now complete for a high availability N3220 filer.
Refer to the
Data ONTAP High Availability and MetroCluster Configuration Guide for 7-Mode
to verify
that the system is set up correctly and ready to operate.
11.
IBM recommends that you enable AutoSupport and then use the AutoSupport feature to view the
health of the system.
Setting up and booting the system in Clustered Data ONTAP
For detailed information about setting up and booting your system in Clustered Data ONTAP, refer to
Clustered Data ONTAP Software Setup Guide
.
Installation and setup instructions
11
Summary of Contents for System Storage N3220
Page 4: ...iv...
Page 20: ...12...
Page 23: ......
Page 24: ...Part Number 00GM241 Printed in USA GA32 2202 02 1P P N 00GM241...
