IBM System storage DS6000 Series, Introduction And Planning Manual, Page: 68 / 119

Item or Setting Instructions Your information
Processor controller card
1 IP Address
Provide the dotted decimal IP
address that you are assigning
for Processor controller card 0
in the DS6800. The current IP
address should either be the
default address (if a new
address has not been
specified) or a user-defined
address (if the default address
had been changed).
Processor controller card
2 IP Address
Provide the dotted decimal
address that you are assigning
to Processor card 1 in the
DS6800. The current IP
address should either be the
default address (if a new
address has not been
specified) or a user-defined
address (if the default address
had been changed).
Gateway 1 Provide the dotted decimal or
symbolic name address of the
gateway (for example,
9.113.155.254 or sanjosegate).
Subnet mask Provide the dotted decimal
address of Subnet (network)
mask.
Primary domain name
server (DNS)
Provide the domain server
name and IP address. You
must fill-in either the Host
name or IP address, or both.
Alternate domain name
server (DNS)
You can optionally provide an
alternate DNS. You must fill-in
either the server name or IP
address, or both.
Maximum transmission
unit (bytes)
You can optionally provide the
maximum rate for transmission.
The valid range is 1 to 9000
bytes.
Simple Network
Management Protocol
(SNMP) destination
Provide the host names or the
dotted decimal addresses of
the destinations that are to
receive SNMP (for example,
destination.com or
9.113.152.254 ).
Simple Mail Transfer
Protocol (SMTP)
Provide either the SMTP server
name or the SMTP IP address.
Host attachment work sheet
Use the host attachment work sheet to record and organize the information that you
need as you map host servers to the DS6000 series drives.
54
Introduction and Planning Guide