IBM Storwize V3700, Quick Installation Manual

Page: 42 / 82

9. Check that the host interface card is installed squarely in its slot and tighten
the retaining thumbscrew
1
.
10.
Reinstall the SFP transceivers. To install a transceiver, push it fully into the
port and close the release handle.
11. If you purchased the additional 2-transceiver option, install the extra SFP
transceivers in the remaining ports.
Installing a 10 Gbps iSCSI-FCoE 2-port host interface card
If you purchased an FC ACHM 10 Gbps iSCSI-FCoE 2-port host interface card that
was not pre-installed for you, you must install it in the node canister.
Before you begin
The 10 Gbps iSCSI-FCoE 2-port host interface card is installed in the node canisters
in the control enclosure. If your control enclosure has two node canisters, you must
install the same options in
both canisters. Do not start installation until you have
two of the 10 Gbps iSCSI-FCoE 2-port host interface card options.
Procedure
To install the host interface card, complete the following steps.
1.
Remove each SFP transceiver from the host interface card. To remove an SFP
transceiver, swing the release handle open and use it to pull the transceiver
out of the port.
22
Storwize V3700: Quick Installation Guide
|
|
|
|
|
|
|
|
|
|