Launch the InitTool program
Optional for Call Home (automated
problem reporting) configuration:
l
l
l
l
Contact: Name, email, telephone
Location: Company name and address
Email server: IP address and port
Personnel to be notified: Email addresses
System management GUI log in:
See the
for detailed
instructions for Linux and Mac OS.
superuser / passw0rd
Quick Installation Guide
Linux
Mac OS
Windows
TM
Page 2
Page 2
Connect cables and power on
Remove the node canisters, turn them over,
and place them on a nonconductive surface.
Press the blue circles to unlock each
cover, then slide it toward the rear
to lift off.
1. Connect Ethernet ( ) port 1 cables to the same subnet, such as ports in the same switch, for example.
2. Connect data cables to any optional host interface cards.
3. To power on, connect a power cable to each power supply. There is no switch.
Initialize the system
Required for configuration:
l
l
l
l
IP address
Subnet mask
Gateway
NTP server (for automated
date and time)
IBM Storwize V3500
Installation Poster
IBM Storwize V3500
Installation Poster
5
5
4
4
Install all drives
2
2
a
a
b
b
Linux is a registered trademark of Linux Torvalds in the United States, other countries, or both.
Mac and Mac OS are trademarks of Apple Inc., registered in the U.S and other countries.
Windows is a trademark of Microsoft Corporation in the United States, other countries, or both.
Install optional host interface cards
3
3
1. Remove fillers required to install all drives.
2. Install all drives.
3. Retain fillers for future use.
3
1
2
1. Loosen the thumbscrew (1).
2. From inside the node canister, move the
filler plate handle (2) slightly to the left
and toward the rear of the node canister.
3. Remove any SFP transceivers from the
host interface card, then put the card (3)
inside the node canister.
c
c
Turn over each node canister to
reinstall it in the control enclosure.
f
f
Reinstall each cover by
sliding it forward until the
locks engage.
e
e
As viewed from inside
the node canister.
v3500044
1. Push the host interface card
against the port opening from
inside the node canister.
2. Engage the tab on the card flange
through the catch slot to the inside,
right of the port opening.
3. Push the host interface card firmly
but gently into the card connector
slot on the node canister.
4. Reinsert any SFP transceivers.
d
d
*1P00Y2661* *GC27422100*
00Y2661
GC27-4221-00
Ethernet ports
USB ports
OK
IN
1
2
1
2
1
2
3
OK
IN
1
2
1
2
1
2
3
Power
Status
Fault
