IBM SP3001, Hardware Configuration Manual

Page: 25 / 50

Setting the Windows Administrator Password
Procedure
1. Start the SiteProtector Console and log in.
2. Select the System view.
3. In the left pane, expand the site node for the SiteProtector SP3001 appliance site, and then click the
Appliance icon.
4. Select the "Click here to connect to appliance" hyperlink. Clicking the hyperlink establishes a Remote
Desktop session with the SiteProtector SP3001 appliance.
5. Log in to the Remote Desktop session on the appliance.
6. Run the User Accounts tool from the Control Panel or run the Local Users and Groups snap-in by
selecting
Start > Run and entering
lusrmgr.msc
.
7.
Change the Windows Administrator password.
8. Click OK .
9. When you are finished, close the Remote Desktop session.
Setting the date and time
The SiteProtector SP3001 appliance uses Windows time synchronization to update its date and time
settings by default. However, you should verify that these settings are correct and change these settings if
necessary.
Procedure
1. Select the System view.
2.
Select the Appliance entry from the left pane.
3. Select the "Click here to connect to appliance" hyperlink. Clicking the hyperlink establishes a Remote
Desktop session with the SiteProtector SP3001 appliance.
4. Log in to the Remote Desktop session on the appliance.
5. Open Date and Time from the Control Panel or select Start > Run and enter timedate.cpl .
6. Specify the correct Date and Time , and then select the correct Time Zone .
7. Click OK .
Chapter 4. Configuring the SiteProtector Console
19