IBM SAN512B-6, Installation, Service And User Manual

Page: 52 / 286

1 - 10-32 x 5/8 in. (1.58 cm) panhead Phillips screw with washer
7. Reinstall the device door if removed from your device. For instructions, refer to
the door removal and replacement procedures in your device installation guide.
Installing the 14U Chassis Mid-Mount Rack Kit for Two-Post Racks
Use the following instructions to install a modular device in a telecommunications
(Telco) rack, using the 14U Chassis Mid-Mount Rack Kit for Two-Post Racks.
The kit is compatible with rack rails that are either 3 inches or 5 inches wide
(adapters are provided for 3-in. rails). Any updates to these instructions will be
added to the hardware installation guide for your product.
Note: Hardware devices illustrated in these procedures are only for reference and
may not depict the device you are installing into the rack.
Time and Items required
Allow approximately one hour to unpack and install a chassis in a rack.
The following tools are required when installing the 14U Chassis Mid-Mount Rack
Kit for Two-Post Racks.
v
Torque wrench with #2 Phillips screwdriver tip.
Figure 8. Attaching port side of device to rack rails
28
SAN512B-6 Installation, Service, and User Guide