IBM SAN512B-6, Installation, Service And User Manual

Page: 241 / 286

29. After you bolt down the rack, go to “Step 7. Attach the front door.”
Step 6. Attach the mounting plates
Note: You attach the front and rear mounting plates through the same mounting
holes that you use to mount the stabilizers. Therefore, you must bolt down the
rack rather than use the stabilizers. Install the mounting plates only if you bolted
the rack to the floor.
The mounting plates are part of the Earthquake Mounting Kit, feature code 6080.
Align the holes on the mounting plate with the holes on the front of the rack. Use
the Allen wrench that is supplied with the rack to install the mounting plate
screws (stabilizer mounting screws). Repeat this procedure for the mounting plate
on the rear of the rack. See Figure 68.
Step 7. Attach the front door
If necessary, perform the following steps to attach the front door. Refer to Figure 69
on page 218 while you perform the steps.
Allen
Wrench
Mounting Plate
Mounting Screw
Front of Cabinet
SJ000658
Figure 68. Attaching the mounting plate
Appendix A. SAN rack
217
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
|
|
|
|