IBM SAN512B-6, Installation, Service And User Manual

Page: 117 / 286

Following is an example of slotShow output.
Note: The most common status is shown. A status of Faulty (51) would display
for a POST failure during power-on or a blade hot-plug.
chassis:admin> slotShow -m
Slot
Blade Type ID Model Name Status
--------------------------------------------------
1 CP BLADE 175 CPX6 ENABLED
2 CP BLADE 175 CPX6 ENABLED
3 SW BLADE 178 FC32-48 ENABLED
4 SW BLADE 178 FC32-48 ENABLED
5 AP BLADE 186 SX6 ENABLED
6 SW BLADE 178 FC32-48 DISABLED
7 CORE BLADE 176 CR32-8 ENABLED
8 CORE BLADE 176 CR32-8 ENABLED
9 SW BLADE 178 FC32-48 ENABLED
10 UNKNOWN VACANT
11 SW BLADE 178 FC32-48 ENABLED
12 SW BLADE 178 FC32-48 ENABLED
switch:admin>
sfpShow
Use this command without operands to display a summary of all installed SFPs.
For each port, the command displays the SFP type and, for serial ID SFP, the
vendor name and SFP, serial number, and speed capability (in Gbps). Use this
command with a port number to display detailed information about the serial ID
SFP in the specified port.
Following is example of
sfpShow
output.
chassis:admin> sfpshow
Slot 3/Port 0: --
Slot 3/Port 1: --
Slot 3/Port 2: --
Slot 3/Port 3: --
Slot 3/Port 4: --
Slot 3/Port 5: --
Slot 3/Port 6: --
Slot 3/Port 7: --
Slot 3/Port 8: --
Slot 3/Port 9: --
Slot 3/Port 10: --
Slot 3/Port 11: --
Slot 3/Port 12: --
Slot 3/Port 13: --
Slot 3/Port 14: --
Slot 3/Port 15: --
Slot 4/Port 0: --
Slot 4/Port 1: --
Slot 4/Port 2: --
Slot 4/Port 3: --
Slot 4/Port 4: --
Slot 4/Port 5: --
Slot 4/Port 6: --
Slot 4/Port 7: --
Slot 4/Port 8: --
Slot 4/Port 9: --
Slot 4/Port 10: --
Slot 4/Port 11: --
Slot 4/Port 12: --
Slot 4/Port 13: --
Slot 4/Port 14: --
Slot 4/Port 15: --
Slot 5/Port 0: --
Slot 5/Port 1: --
Slot 5/Port 2: --
Slot 5/Port 3: --
Slot 5/Port 4: --
Slot 5/Port 5: --
Slot 5/Port 6: --
Chapter 6. Monitoring the switch
93