IBM SAN50C-R, Installation, Service And User Manual

Page: 55 / 86

Before Installing the Rack-Mount Support Brackets
Before installing the rack-mount support brackets for the IBM SAN50C-R switch,
check the contents of the optional shelf bracket kit against those listed in the
following table.
Table 6. Contents of Shelf Bracket Kit
Quantity Part Description
2 Bottom support brackets
20 12-24 x 3/4-in. Phillips screws
20 M6 x 19 mm Phillips binder-head screws
2 10-32 x 3/8-in. Phillips pan-head screws
Installing the Switch on the Shelf Brackets
This section provides information on how to install and remove brackets. Before
installing the shelf brackets, check the contents of your kit against the items in the
following table.
Table 7. Contents of Shelf Bracket Kit
Quantity Part Description
2 Slider brackets
2 Shelf brackets
1 Crossbar
2 10-32 x 3/8-in. Phillips pan-head screws
16 12-24 x 3/4-in. Phillips screws
16 10-24 x 3/4-in. Phillips screws
Required equipment
You need the following equipment for this installation
v Number 2 Phillips screwdriver
v
Tape measure and level (to ensure shelf brackets are level)
Installing the Shelf Bracket Kit into a Four-Post EIA Rack
The following graphic shows the installation of the shelf bracket kit into a
four-post EIA rack.
Chapter 3. Cabinet and Rack Installation
31