IBM SAN48B-5, Installation, Service And User Manual

Page: 39 / 84

Attaching the rear brackets to the cabinet rails
Complete the following steps to attach the rear brackets to the cabinet rails.
1.
Attach the right rear bracket
2
to the right rear cabinet rail using two 10-32 x
5/8 in. screws
4
and two retainer nuts
3
, as shown in Figure 7.
2. Repeat step 1 to attach the left rear bracket to the left rear cabinet rail and
tighten all the 10-32 x 5/8 in. screws to a torque of 25 in-lb (29 cm-kg).
3
2
1
4
b48f005
Figure 7. Attach the rear bracket to the cabinet rail
Chapter 2. Installing and configuring the switch
13