IBM SAN384B-2, Installation, Service And User Manual

Page: 155 / 190

Avoid double encryption
Encryption and decryption at the storage device level does not affect the
encryption switch or blade capabilities, and does not cause problems with
decrypting the data. However, double encryption adds the unnecessary need to
manage two sets of encryption keys, increases the risk of losing data, may reduce
performance, and does not add security.
FC7230 - Installing FIPS 140-2 Level 2 tamper proof seals
The majority of the seals in this feature can be installed while the SAN384B-2 is
operational. However, there are several seals that may be difficult to apply to the
chassis and port side exhaust kit if the chassis is already installed in a cabinet. Plan
the installation of the chassis and other features accordingly. Refer to the separate
publication,
IBM System Storage FIPS 140-2 Security Seal Application Procedures
(GA32-2220-00), for installation instructions of these seals for several different
models. This publication is available through the IBM Support Portal
www.ibm.com/supportportal and the IBM Publications Center
www.ibm.com/shop/publications/order.
FC7871 - Installing a QSFP and inter-chassis license
This feature can be installed while the SAN384B-2 is operational.
Time required
Less than 10 minutes, not including installation of the ICL license or any needed
configuration.
Items required
v
QSFPs and four ICL cables
v FC 7871 (ICL license) is required for each chassis that you are connecting.
Instructions for installation are included with that license feature.
Procedures
Attention: If ICL cables are not in use, rubber plugs must be inserted in the
QSFPs.
Follow the links in the steps below to complete this installation.
1. Verify that the QSFP is the correct part: 99Y0377.
2.
Verify with the customer that the ICL license is installed on each chassis to be
connected. Enter the
licenseIdShow command for each chassis. If required,
install the ICL license, following the instructions included with the license.
3. Remove the chassis door (“Removing and installing the chassis door” on page
67).
4. Determine the cable routing and QSFP ports on the core switch blades that you
will be using to connect the two chassis.
5.
Remove the rubber plugs from the QSFP ports on the core blades that you will
be connecting. Save the plugs for possible future use.
6. Install the two QSFPs and ICL cables (“Removing and replacing inter-chassis
link (QSFP) cables” on page 93).
7.
Install the chassis door (“Removing and installing the chassis door” on page
67).
Chapter 6. Installing new features
123
|
|
|
|
|
|
|
|
|
|