IBM SAN Volume Controller 2145-CG8, Hardware Installation Manual

Page: 89 / 110

SAN Volume Controller 2145-CG8 ports used during service
procedures
The SAN Volume Controller 2145-CG8 contains a number of ports that are only
used during service procedures.
Figure 48 shows ports that are used only during service procedures.
1
System management port
2
Two monitor ports, one on the front and one on the rear
3
Four USB ports, two on the front and two on the rear
During normal operation, none of these ports are used. Connect a device to any of
these ports only when you are directed to do so by a service procedure or by an
IBM service representative.
SAN Volume Controller 2145-CG8 unused ports
The SAN Volume Controller 2145-CG8 can contain one port that is not used.
Figure 49 on page 62 shows the one port that is not used during service procedures
or normal use.
Ground
Live
Neutral
Figure 47. Power connector
svc00724
1 2 3
3
2
Figure 48. Service ports of the SAN Volume Controller 2145-CG8
Appendix C. SAN Volume Controller hardware controls, indicators, and connectors
61