IBM SAN Volume Controller 2145-CG8, Hardware Installation Manual

Page: 53 / 110

3. Place the bracket over the power outlets on the right rear of the 2145 UPS-1U,
so that the two screw holes line up.
4.
Position the bracket with the power cable protruding through the rightmost slot
in the bracket.
5. Secure the bracket in place with one screw on each side, as shown in Figure 19.
Installing the SAN Volume Controller 2145-CG8
There are several steps that you must perform to install the SAN Volume
Controller 2145-CG8 node.
About this task
Installing the SAN Volume Controller 2145-CG8 consists of the following tasks:
1. Installing the support rails in the rack cabinet.
2. Installing the SAN Volume Controller 2145-CG8 node.
3. Installing the cable-management arm in the rack cabinet.
4. Connecting the SAN Volume Controller 2145-CG8 node to the uninterruptible
power supply.
svc00201
Figure 18. 2145 UPS-1U power cable-retention bracket hardware
Figure 19. 2145 UPS-1U power cable-retention bracket
Chapter 2. Installing the SAN Volume Controller 2145-CG8 hardware
25