IBM SAN Volume Controller 2145-CG8, Hardware Installation Manual

Page: 41 / 110

About this task
Perform the following steps to attach the mounting plates to the redundant
ac-power switch.
Procedure
1. Attach each of the two mounting plates to the redundant ac-power switch
using three M3 Torx T8 head screws.
2. Position the mounting face on the side of the redundant ac-power switch
containing the output power sockets. See Figure 4.
Labeling the cables
You must label each end of the two redundant ac-power switch input-power cables
before you connect the input-power cables to the redundant ac-power switch.
About this task
Perform the following steps to label each end of the two redundant ac-power
switch input-power cables:
Procedure
1. Label the rack power-distribution end “Power source <name>, outlet <id> to
redundant ac-power switch <location> <MAIN | BACKUP> input.” For
example, “Power source D2, outlet 4 to redundant ac-power switch pos 7
MAIN input.” One cable is labeled “MAIN;” the other is labeled “BACKUP.”
2. Label the redundant ac-power switch end “redundant ac-power switch
<location> <MAIN | BACKUP> input from Power source <name>, outlet
<id>.” One cable is labeled “MAIN;” the other is labeled “BACKUP.”
Connecting the input-power cables to the redundant ac-power
switch
You will find it easier to connect the input-power cables to the redundant ac-power
switch before you install the redundant ac-power switch in the rack.
About this task
Perform the following steps to connect the input-power cables to the redundant
ac-power switch:
svc00294
Figure 4. Attaching the mounting plates
Chapter 2. Installing the SAN Volume Controller 2145-CG8 hardware
13